PCC (Power Control Centre) Panels are used to supervise and control the voltage and power of the power system.

DOL starting is simply switching the motor on in one operation, with a direct connection from the power source.

AMF and ATS panels monitor the incoming AC mains supply, activate the standby generator when mains power fails

What Is a Star Delta Starter? Star delta starters are another device that may be used to reduce current demand during motor startup.

A Motor Control Center (MCC) is an assembly that controls several or all-electric motors centrally.

To state simply, a generator control panel is used to automatically start and stop a generator's motor.

LT Panels are used with low tension cables to obtain power from the generator or transformer

As briefly mentioned, a distribution panel is the main source of a large set of electrical circuits.

The sub distribution panel or board consists of a basic frame with all the necessary electrical components such as main isolating switches

An MCB is a type of circuit protection device that automatically interrupts the flow of electrical current in a circuit if a fault or overload is detected.

APFC it is used to improve the power factor, whenever required, by switching ON and OFF the required capacitor bank units automatically.

The meter box is a special box for electricity metering, such as ammeter, watt hour meter, power meter, etc.

ACB is an electrical device used to provide Overcurrent and short-circuit protection for electric circuits over 800 Amps to 10K Amps.

Electric meter or energy meter measures the total power consumed over a time interval.

A changeover switch transfers the house electricity from the commercial power grid to the local generator.

MCCB Panelboards are durable and easy to install panelboards that offer superior protection from excessive current loads and short circuit faults.